The Clement ScrapStar Mark II
The Clement ScrapStar Mark II for rugged, unrestricted scrap.
Premium Components are standard on the ScrapStar. Money is made on the road, not in the repair shop.
37-ft., 62-cubic yard Frameless Scrap Trailer
You don’t see savvy scrap haulers buying the same trailer again and again unless it’s making them money, lots of money. Clement ScrapStar, Mark II is designed and configured for maximum profitability with high-strength, abrasion resistant steel (AR450) that gives you the ability to haul the full spectrum of scrap. Premium components, which are options on competitor’s trailers are standard of every Scrapstar. That’s because money is made on the road, not in a repair shop. Add Clement’s superior design and construction and you have a solid moneymaker.
Clement Bathtub Bodies
The Clement Bathtub body, with its 8 inch radius wrap floor with no center seam, is supported by longitudinals rather than cross members. This design has been so successful that it has become the most imitated body in the industry. Urethane Paint
A Class-8, truck-quality urethane paint is applied to ensure maximum protection and long life.
102” Axles by Meritor
 Proven in hundreds of thousands of trailers, the 25,000# axles used in Clement Scrap trailers feature common inner and outer bearings. In combination with Meritor’s parallel spindle, both axle and bearing life is substantially increased.
Clement’s Inverted Cylinder
With an inverted cylinder there’s no doghouse. An inverted cylinder has no ledges to collect dirt, water and ice, so the cylinder packing remains clean with no dirt pulled into the system. In an inverted cylinder, oil lays on the seals when the trailer is not in use, keeping the seals lubricated to prevent dryout and cracking. |
SPECIFICATIONS
CHASSIS
Suspension: 50,000 # Single Point – 3 Leaf Axles: (2) 102″, 25,000 lb, 5″Round, Common Inner/Outer Bearings Wheels: 8.25 x 24.5, 10 Hole Hub-Piloted Disc
Tires: 11 x 24.5 Radial
Hubs: 10 Hole Pilot Hub
Brakes: Air 16 1/2″ x 7″ Outboard Cast Drum;
ABS: 2S 1M Axle Spacing: 51″
Lights: 12 Volt Sealed Beam, Rubber Grommet
Wiring: Sealed Harness Modular Plug In Mud Flaps: Rubber Rear Only
Draft Arms: 3″x 4″x 1/8 Tubing
King Pin Plate: 1/4″ AR450 (Rocking/Breakaway)
Back-up Alarm: Yes
BODY
Type: Steel Bathtub style body for steel scrap & demolition
Floor: Full Wrap: 1/4″ AR450
Sides: 3/16″ AR450
Tailgate: Barndoor 3/16″ AR450
Front: 3/16″ AR450
Paint: One color urethane enamel over primed surface
Longitudinal: 4″x 8″x 3/16″ Tubing
Top Rail: 4″x 4″x 3/16″ Tubing
Side Braces: 3/16″
Hoist Housing: None – Inverted Outside Hydraulic Cylinder
Click Here for Brochure
|
(630) 739-4330
Comments on this entry are closed.